RM-10© Wastewater Treatment Clay

RM-10 is a proprietary blend of clay minerals, polymers and pH adjusting agents, which allow one-step entrapment of emuslified oils and dissolved metals from various industrial waste streams.

 

SAMPLE ANALYSIS OF TUMBLING WASH & RINSE TANKS

Wastewater Evaluation Report

Laboratory tests on samples submitted indicate the following
before and after treatment*

TREATMENT: (estimated per 100 gal wastewater)

   1.  Add approximately 0.6 gallons of CETcoag™ CA103 and 

        mix.

   2.  Adjust pH to 10 with Sodium Hydroxide

   3.  Add approximately 2.9 lbs RM-10 2009, mix until

        flocculation and water clarity is complete, and then

        filter.

RESULT

This treatment was successful in reducing the contaminants analyzed for in the submitted sample.

---

Sludge Evaluation Report

The Toxicity Characteristic Leaching Procedure (TCLP) (Federal Register, Vol. 55, No. 126/June 29, 1990) was performed on the submitted RM-10 sludge.  The leachate was tested for the following metals.

Metals (mg/L)	RM-10 Sludge	Limits (mg/L)
Arsenic	0.01	5.0
Barium	0.54	100.0
Cadmium	0.006	1.0
Chromium	0.09	5.0
Lead	<0.02	5.0
Mercury	0.06	0.2
Selenium	0.07	1.0
Silver	<0.005	5.0

RESULT:

The sludge produced by the RM-10 treatment met the limits set by the Toxicity Characteristic Leaching Procedure (TCLP) (Federal Register, Vol. 55, No. 126/June 29, 1990).

---

RM-10 is that easy to use! Our system offers a simple alternative to the cost of hauling away wastewater to be treated off-site, while ensuring that treated effluent will meet Publicly Owned Treatment Works (POTW) discharge limits established by local and state authorities.

RM-10 provides an economical and environmentally sound solution to your facilities wastewater.

• Wastewater Treatment Equipment